Home > Error Codes > Samsung Washer > SUD
Samsung Washer Error Code SUD
Too many suds (foam) were detected in the tub.
Also shown as: 5UD, SUd, Sd, 5d, SUdS Last verified: 2026-10-30
Most likely causes, in order
| Cause | How common |
|---|---|
| Too much detergent for the load size | Most common |
| Non-HE detergent in a high-efficiency washer | Common |
| Detergent residue built up in the drum and dispenser over many washes | Common |
What to try, easiest first
- Do nothing for a few minutes — the washer pauses on purpose to let foam settle, then usually resumes on its own.
- If it stays paused, run a Rinse + Spin cycle with no detergent at all.
- For the next wash, use the smaller dose marked for your load size and confirm the detergent says HE (high efficiency).
- If foam returns on every wash even with a small HE dose, run a drum-clean / Self Clean cycle to clear residue.
Reset procedure
Soft reset (first try): press Power to switch the washer off, wait about 2–3 minutes, switch it back on and restart the cycle. If the code was a one-off sensor glitch, it often clears here.
Hard reset: switch the washer off, unplug it from the wall outlet (or switch its breaker off) for 2–3 minutes, plug it back in and restart. Never open a panel or touch wiring while it is plugged in.
When to call a technician
Call a technician only if foam keeps returning after the detergent and drum-clean steps, or water leaks from the dispenser during foaming.
Difficulty, time and cost
| Difficulty | Easy |
|---|---|
| Typical DIY time | 5–15 minutes plus waiting time (editorial estimate, not a quoted time) |
| Part / job cost | $0 — no part is involved. No part cost applies; the fix is detergent dose and a rinse or drum-clean cycle. Prices vary by model and area — treat every figure as an estimate, not a quote. |
Model notes and limits
Displays render this fault several ways — SUD, 5UD, SUd, Sd — because of how the small display shapes letters. All of them mean excess foam, not a broken part.
Front-load and top-load models, AddWash/FlexWash models, and US versus UK displays can show the same fault differently. Always confirm against the manual for your exact model number (on the label inside the door or lid, or on the back of the washer) before ordering a part.
Related codes
Frequently asked questions
Is this code actually an error?
No. It is a warning that foam is too high. The washer pauses, lets foam settle, and usually finishes the cycle by itself.
I used the capful the bottle suggested. Why too much foam?
Bottle doses assume a full, heavily soiled load and soft water. A small load or soft water needs much less — start at half the marked dose.
Can too much foam damage the washer?
Occasionally, no. Repeatedly, yes — foam can push water past seals and confuse the level sensor, so fix the dose rather than ignoring it.
Sources
- Solo Appliance Repair — Samsung washer error code list — https://soloappliancerepair.com/comprehensive-guide-to-samsung-washing-machine-error-codes/ (checked 2026-10-30)
- FixCodeGuides — Samsung washer error codes — https://fixcodeguides.com/samsung-washer-error-codes (checked 2026-10-30)
- WashingCodes — Samsung top-load washer error codes — https://washingcodes.com/samsung-wa52j8060a-wa52j8700a-top-load-washer-with-activewash-error-codes/amp/ (checked 2026-10-30)